Alcatel-Lucent 1830 PSS-16 - EQPTDGR (Card Degrade - Device)

...................................................................................................................................................................................................
1
Perform a warm reset of the card.
CLI config card card type shelf slot reset warm
WEBUI Select the card, click the Reboot tab, select Warm Reboot >Submit.
...................................................................................................................................................................................................
2
Perform a cold reset of the card.
Note: Refer to Caution at the beginning of this procedure.
CLI config card card_type shelf slot reset cold
WEBUI Select the card, click the Reboot tab, select Cold Reboot >Submit.
...................................................................................................................................................................................................
3
Reseat the card. Refer to “Reseating a Card” (p. 3-19).
...................................................................................................................................................................................................
4
Replace the card. Refer to “Replacing System Components” (p. 3-20). Follow the return
and repair process in the Customer and Product Support guide to return the faulty card to
an authorized repair center for replacement.
EQPTDGR
EQPTDGR (Card Degrade - device)
The Card Degrade-Device alarm text for the EQPTDGR condition indicates a fault on the
card that has caused the system to declare a hardware failure. This condition may be
declared due to a failure in the SEEP or other unknown hardware failures depending on
the card type the alarm is raised against.
The Card Degrade-Device alarm text indicates a lower priority fault on the card that does
not directly affect the traffic currently flowing through the device.
Severity Minor
Service affecting? No
Trouble-clearing procedures
EQPTBOOT
EQPTBOOT (Card failure - boot failure)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
2-75
E ND OF STEPS
...................................................................................................................................................................................................