WEBUI Select a card or port on the Equipment Tree.
Set the Primary State field to
Maintenance.
...................................................................................................................................................................................................
2
Perform a cold restart of the entire NE, instead of each individual card.
CLI config admin force resetne
reset cold
WEBUI Select the System on the Equipment Tree for the NE.
Click the
Reboot tab.
Select
Cold Reboot >Submit.
Reseating a Card
Procedure
NOTICE
Service-disruption hazard
A card reseat is service impacting if the card is currently carrying services. To discover if
any services are currently carried over a card, perform the procedure “Checking for
Services
on a Port” (p. 3-10). If there are services currently carried over the card, it may
be
best to wait for a maintenance window before reseating the card.
...................................................................................................................................................................................................
1
Ensure that all of the fibers connected to the card are labeled.
...................................................................................................................................................................................................
2
Remove and cap all of the fibers connected to the card.
...................................................................................................................................................................................................
3
Unlock the card latch. Place a thumb or finger on the latch release/locking pin located
behind the latch cover and open the latch by lifting up and out. This will partially unseat
the card from the backplane.
Supporting procedures
Rebooting Components
Cold Restart of a Pack with Traffic
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
3-19
E ND OF STEPS
...................................................................................................................................................................................................
To Next Page
Loading...
