EasyManua.ls Logo

Alcatel-Lucent 1830 PSS-16 - Page 626

Alcatel-Lucent 1830 PSS-16
722 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
...................................................................................................................................................................................................
5
Configure the database server setting and restore the valid R2.5 database.
CLI
1.
config database server
Add the next applicable command to the string as follows:
detail—Display software server information
ip—Configure the remote backup/restore server IP address
protocol—Configure the remote backup/restore protocol
userid—Configure the userid for accessing the backup/restore serve
2.
config database path
3. config database restore
WEBUI See “Restoring a Database” (p. 3-14) for applicable steps.
...................................................................................................................................................................................................
6
One the database is restored successfully, perform the software upgrade procedure for
R2.5.
n
to R3.0.2.
Rebooting Components
Cold Restart of a Pack with Traffic
Performing a cold restart of a transmission-carrying pack is service affecting. Thus, cold
restart is not allowed on packs when they are in-service. (The pack must either be in
maintenance state, or out-of-service.)
The following procedure is a workaround to perform a cold restart on a
transmission-carrying card for special reasons, such as verifying whether transmission
recovers after the restart is completed.
...................................................................................................................................................................................................
1
Put the card (and ports) into maintenance state before performing the cold restart. In
maintenance state, the cross connects can remain in place, and transmission is still
carried.
CLI For cards: config slot state mt
For ports: config interface state mt
Supporting procedures
Software Upgrades
Restoring an NE in DBINVALID State
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
3-18
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
E ND OF STEPS
...................................................................................................................................................................................................

Table of Contents

Related product manuals