Alcatel-Lucent 1830 PSS-16 - Page 352

FPGATIMEOUT
FPGATIMEOUT (FPGA Timeout)
The FPGATIMEOUT alarm is raised when the card fails to download firmware and
complete FPGA programming in a period of time (about 45 minutes).
Severity MN
Service affecting? No
Applicability 112SA1L, 112SCA1, 112SCX10, 112SX10L, 11DPE12E,
11DPM12, 11STAR1, 11STMM10, 11STGE12, 4DPA2, 4DPA4,
43SCX4, 43STA1P, 43STX4, 43STX4P, ALPHG, AHPHG,
AHPLG, ALPFGT, AM2318A, CWR8, CWR8-88, MESH4,
MVAC, OPS, OSCT, SVAC, WTOCM
Corrective Action
...................................................................................................................................................................................................
1
Perform a warm reset on the card where the FPGATIMEOUT condition is raised.
CLI config card card type shelf slot reset warm
WEBUI Select the card, click the Reboot tab, select Warm Reboot >Submit.
FRCDSWTIMREF
FRCDSWTIMREF (Forced Switch Timing Reference)
The OT port has detected an FRCDSWTIMREF condition at the LINEREF layer. A
LINEREF detects FRCDSWTIMREF when the timing selection is forced to a timing
reference.
Severity NA
Service affecting? No
Applicability LINEREFSYS
Trouble-clearing procedures FPGATIMEOUT (FPGA Timeout)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
2-102
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
E ND OF STEPS
...................................................................................................................................................................................................