The Lock out of a Timing Reference from selection condition occurs when the OT port
has detected an LOCKOUTOFTIMREF at the LINEREF layer.
Severity NA
Service affecting? No
Applicability LINEREFSYS
Corrective Action
...................................................................................................................................................................................................
1
Check the timing reference quality and priority.
CLI show card 11dpe12e
shelf/slot
synce lineref
{1-4}
WEBUI Select the 11DPE12E card in the Equipment Tree.
Select LINEREF {1-4}.
LOF
LOF (Loss Of Frame)
A receive port on one of the optical cards has detected a Loss Of Frame. The LOF alarm
is raised if:
• the SONET framer detects framing errors in the A1/A2 overhead bytes as per the
SONET specification
• the OTN framer detects corruption in the Framing Alignment Signal (FAS) bytes.
This may be caused by the following reasons:
• A misconnected, damaged or dirty fiber
• The received power may not be within the acceptable range
• The data rate may be inconsistent
Severity Critical
Service affecting? Yes
Trouble-clearing procedures
LOCKOUTOFTIMREF
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
2-135
E ND OF STEPS
...................................................................................................................................................................................................