Alcatel-Lucent 1830 PSS-16 - Page 442

To delete an existing shelf:
CLI config shelf <shelf> type empty
WEBUI In the Equipment Tree, select the desired shelf (not the Main shelf).
Click the Delete tab.
Select
Delete this Shelf, and click Submit.
...................................................................................................................................................................................................
4
If the correct serial number is provisioned, but the wrong DCM or SFD44 module is
connected, replace the module with one which has the correct serial number.
MISMATCHMOD
MISMATCH (Pluggable Module Mismatch)
This condition indicates that either the detected shelf identifier does not match the
provisioned shelf identifier, or an pluggable module is installed on an Egress LD.
a
Severity Critical
Service affecting? Yes
Applicability 112SA1L, 112SCA1, 112SCX10, 112SX10L, 11STAR1,
11STMM10, 11STGE12, 43SCX4, 43STX4, , 4DPA2, 4DPA4,
AM2017B, AM2325B, AHPHG, AHPLG, ALPHG, ALPFGT,
OSCT
Trouble-clearing procedures
MISMATCH
MISMATCH (Shelf Mismatch)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
2-192
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
E ND OF STEPS
...................................................................................................................................................................................................