Replacing an SFP Module
...................................................................................................................................................................................................
1
Ensure that all of the fibers connected to the SFP module are labeled.
...................................................................................................................................................................................................
2
Remove and cap all of the fibers connected to the SFP module.
...................................................................................................................................................................................................
3
Insert SFP extraction tool into SFP.
...................................................................................................................................................................................................
4
Gently push in bottom wedge on SFP extraction tool to release SFP retention spring.
...................................................................................................................................................................................................
5
Pull on body of SFP extraction tool to remove SFP.
Figure 3-1 Push in wedge
Supporting procedures
Replacing System Components
Replacing an SFP Module
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
3-27
To Next Page
Loading...
