Alcatel-Lucent 7705 SAR - Configuring Access Options

SNMP
7705 SAR OS System Management Guide 175
The following example displays the view configuration:
ALU-1>config>system>security>snmp# info
----------------------------------------------
view "testview" subtree 1
mask ff
exit
view testview subtree 1.3.6.1.2
mask ff type excluded
exit
community "private" rwa version both
community "public" r version v2c
----------------------------------------------
ALU-1>config>system>security>snmp#
Configuring Access Options
The access command creates an association between a user group, a security model, and
the views that the user group can access. Access must be configured unless security is limited
to the preconfigured access groups and views for SNMPv1 and SNMPv2c. An access group
is defined by a unique combination of the group name, security model, and security level.
Use the following CLI syntax to configure access features:
CLI Syntax: config>system>security>snmp
access group group-name security-model security-
model security-level security-level [context
context-name [prefix-match]] [read view-name-1]
[write view-name-2] [notify view-name-3]
The following example displays access command usage:
Example: ALU-1>config>system>security>snmp# access group
testgroup security-model usm security-level auth-no-
privacy read testview write testview notify testview
The following example displays the access configuration with the view configurations.
ALU-1>config>system>security>snmp# info
----------------------------------------------
view “testview” subtree 1
mask ff
exit
view “testview” subtree 1.3.6.1.2
mask ff type excluded
exit
access group “testgroup” security-model usm security-level auth-no
-privacy read “testview” write “testview” notify “testview”
community "public" r version both
----------------------------------------------