Event and Accounting Logs
7705 SAR OS System Management Guide 235
Configuring Event Control
Use the following CLI syntax to configure event control. Note that the throttle parameter
used in the event-control command syntax enables throttling for a specific event type.
The config>log>throttle-rate command configures the number of events and
interval length to be applied to all event types that have throttling enabled by this event-
control command.
CLI Syntax: config>log
event-control application-id [event-name | event-
number] generate [severity-level] [throttle]
event-control application-id [event-name | event-
number] suppress
throttle-rate events [interval seconds]
The following displays an example of an event control configuration command syntax:
Example: config# log
config>log# event-control atm 2014 generate critical
config>log# event-control oam 2001 suppress
config>log# throttle-rate 500 interval 10
The following displays the event control configuration:
ALU-12>config>log# info
#------------------------------------------
echo "Log Configuration"
#------------------------------------------
throttle-rate 500 interval 10
event-control "atm" 2014 generate critical
event-control "oam" 2001 suppress
..
----------------------------------------------
ALU-12>config>log>filter#
Configuring Throttle Rate
This command configures the number of events and interval length to be applied to all event
types that have throttling enabled by the event-control command.
Use the following CLI syntax to configure the throttle rate.
CLI Syntax: config>log#
throttle-rate events [interval seconds]
To Next Page
Loading...
