Alcatel-Lucent 7705 SAR - Configuring a Syslog Target

Common Configuration Tasks
238 7705 SAR OS System Management Guide
The following displays an example of the SNMP trap group configuration command syntax:
Example: config# log
config>log# snmp-trap-group 2
config>log>snmp-trap-group# trap-target "target name"
address 10.10.10.104 notify-community
"communitystring" security-level no-auth-no-privacy
config>log>snmp-trap-group# exit
The following displays the SNMP trap group configuration:
ALU-12>config>log# info
----------------------------------------------
...
snmp-trap-group 2
trap-target “target name” address 10.10.10.104:5 "snmpv3" notify-community
"communitystring"
exit
...
log-id 2
description "This is a test log file."
filter 1
from main security
to file 1
exit
...
----------------------------------------------
ALU-12>config>log#
Configuring a Syslog Target
Log events cannot be sent to a syslog target host until a valid syslog ID exists.
Use the following CLI syntax to configure a syslog file:
CLI Syntax: config>log
syslog syslog-id
address ip-address
description description-string
facility syslog-facility
level {emergency | alert | critical | error |
warning | notice | info | debug}
log-prefix log-prefix-string
port port