Log Command Reference
308 7705 SAR OS System Management Guide
syslog
Syntax syslog [syslog-id]
Context show>log
Description This command displays syslog event log destination summary information or detailed information on
a specific syslog destination.
Parameters syslog-id — displays detailed information on the specified syslog event log destination
Values 1 to 10
Output The following output is an example of syslog event log destination summary information, and Table 49
describes the fields.
Sample Output
*A:ALU-48>config>log# show log syslog
===============================================================================
Syslog Target Hosts
===============================================================================
Id Ip Address Port Sev Level
Below Level Drop Facility Pfx Level
-------------------------------------------------------------------------------
2 unknown 514 info
0 local7 yes
3 unknown 514 info
0 mail yes
===============================================================================
*A:ALU-48>config>log#
Table 48: SNMP Trap Group Output Fields
Label Description
Log-ID The log destination ID for an event stream
Address The IP address of the trap receiver
Port The destination UDP port used for sending traps to the destination,
expressed as a decimal integer
Version Specifies the SNMP version format to use for traps sent to the trap
receiver. Valid values are snmpv1, snmpv2c, snmpv3.
Community The community string required by snmpv1 or snmpv2c trap receivers
Security-Level The required authentication and privacy levels required to access the
views on this node
To Next Page
Loading...
