Alcatel-Lucent 7705 SAR - Configuring a Log Filter

Common Configuration Tasks
236 7705 SAR OS System Management Guide
The following displays an example of the configuration command syntax:
Example: config>log# throttle-rate 500 interval 10
config>log# event-control mpls 2001 generate throttle
The following displays the configuration:
*A:gal171>config>log# info
---------------------------------------------
throttle-rate 500 interval 10
event-control “mpls” 2001 generate throttle
----------------------------------------------
*A:gal171>config>log#
Configuring a Log Filter
Use the following CLI syntax to configure a log filter:
CLI Syntax: config>log
filter filter-id
default-action {drop | forward}
description description-string
entry entry-id
action {drop | forward}
description description-string
match
application {eq | neq} application-id
number {eq | neq | lt | lte | gt |
gte} event-id
router {eq | neq} router-instance
[regexp]
severity {eq | neq | lt | lte | gt |
gte} severity-level
subject {eq | neq} subject [regexp]
The following displays an example of the log filter configuration command syntax:
Example: config# log
config>log# filter 1
config>log>filter# description "This is a sample filter."
config>log>filter# default-action drop
config>log>filter# entry 1
config>log>filter>entry$ action forward
config>log>filter>entry# match application eq atm
config>log>filter>entry# match severity eq critical
config>log>filter>entry# exit