Event and Accounting Logs
7705 SAR OS System Management Guide 277
Syslog Commands
syslog
Syntax [no] syslog syslog-id
Context config>log
Description This command creates the context to configure a syslog target host that is capable of receiving selected
syslog messages from the 7705 SAR.
A valid syslog-id must have the target syslog host address configured.
A maximum of 10 syslog IDs can be configured.
No log events are sent to a syslog target address until the syslog-id has been configured as the log
destination (to) in the log-id node.
Default No syslog IDs are defined.
Parameters syslog-id — the syslog ID number for the syslog destination, expressed as a decimal integer
Values 1 to 10
address
Syntax address ip-address
no address
Context config>log>syslog
Description This command associates the syslog target host IP address with the syslog ID.
This parameter is mandatory. If no address is configured, syslog data cannot be forwarded to the syslog
target host.
Only one address can be associated with a syslog-id. If multiple addresses are entered, the last address
entered overwrites the previous address.
The same syslog target host can be used by multiple log IDs.
The no form of the command removes the syslog target host IP address.
Default no address
To Next Page
Loading...
