Security Command Reference
80 7705 SAR OS System Management Guide
The no form of the command removes the specified source address from the application, causing the
application to use the system IP address as the source address.
Parameters app — specifies the application name
Values telnet, ftp, ssh, radius, tacplus, snmptrap, syslog, ping, traceroute,
dns, sntp, ntp
ip-int-name | ip-address — specifies the name of the IP interface or IPv4 address. If the string
contains special characters (#, $, spaces, etc.), the entire string must be enclosed within
double quotes.
application6
Syntax application app ipv6-address
no application app
Context config>system>security>source-address
Description This command specifies the application to use the source IPv6 address specified by the source-
address command.
The no form of the command removes the specified source address from the application, causing the
application to use the system IP address as the source address.
Parameters app — specifies the application name
Values telnet, ftp, radius, tacplus, snmptrap, syslog, ping, traceroute, dns
ipv6-address — specifies the IPv6 address
telnet-server
Syntax [no] telnet-server
Context config>system>security
Description This command enables Telnet servers running on the system.
Telnet servers are off by default. At system startup, only SSH servers are enabled.
Telnet servers in 7705 SAR networks limit a Telnet client to three retries to log in. The Telnet server
disconnects the Telnet client session after three retries.
The no form of the command disables Telnet servers running on the system.
Default no telnet-server
To Next Page
Loading...
