Managing Power over Ethernet (PoE) Power over Ethernet Specifications
OmniSwitch 6850E Series Hardware Users Guide January 2013 page 5-3
Power over Ethernet Specifications
The table below lists general specifications for Alcatel-Lucent’s Power over Ethernet support. For more
detailed power supply and Power Source Equipment (PSE) specifications, refer to Chapter 3,
“OmniSwitch 6850E Series Power Supplies.”
IEEE Standards supported
IEEE 802.3at
PoE Class Detection Supported
Default PoE administrative status Enabled
Default PoE operational status Disabled (PoE must be activated on a switch-
by-switch basis via the lanpower start com-
mand.)
Platforms supporting PoE PoE Models
Default amount of inline power available for each port 30000 milliwatts
Range of inline power allowed for each port 3000-30000 milliwatts
Default amount of PoE power per slot 510W power supply - 390W
360W power supply - 240W
900W power supply - 780W
Maximum PoE power per slot 510W power supply - 390W
360W power supply - 240W
900W power supply - 780W
To Next Page
Loading...
Need help?
General
