Monitoring Power over Ethernet via CLI Managing Power over Ethernet (PoE)
page 5-12 OmniSwitch 6850E Series Hardware Users Guide January 2013
Monitoring Power over Ethernet via CLI
To monitor current PoE statistics and settings, use the show lanpower command. The command output
displays a list of all current PoE-capable, along with the following information for each port:
• Maximum power available to the port, in milliwatts
• Actual power used by the port
• Current port status
• Power priority status
• Power on/off status
Aggregate slot and chassis management information is also displayed. This information includes:
• Maximum watts available to the corresponding slot
• Amount of power budget remaining for PoE modules
• Total amount of power remaining for additional switch functions
When entering the show lanpower command, you must include a valid slot number in the command line
syntax. For example:
-> show lanpower 1
Port Maximum(mW) Actual Used(mW) Status Priority On/Off Class
----+-----------+---------------+-----------+---------+--------+-------
1 30000 12500 Powered On Low ON 0
2 30000 1800 Powered On Low ON 1
3 30000 3500 Powered On Low ON 2
4 30000 9800 Powered On Low ON 3
5 30000 25000 Powered On Low ON 4
6 30000 0 Undefined Low ON -
7 30000 0 Undefined Low ON -
8 30000 0 Undefined Low ON -
9 30000 0 Undefined Low ON -
(output truncated)
21 30000 0 Undefined Low ON -
22 30000 0 Undefined Low ON -
23 30000 0 Undefined Low ON -
24 30000 0 Undefined Low ON -
Slot 3 Max Watts 150
1 Power Supplies Available
Note. For detailed information on show lanpower command output, refer to the OmniSwitch CLI Refer-
ence Guide.
To Next Page
Loading...
