OmniSwitch 6850E Series Chassis and Hardware Components Setting Up a Stacked Configuration
OmniSwitch 6850E Series Hardware Users Guide January 2013 page 2-39
3 Insert the other end of the stacking cable into the stacking port of the switch immediately below. Once
again, the stacking port (A or B) depends on the preferred cabling pattern.
4 Repeat this procedure until all switches in the stack are connected (see illustrations a, b, and c below).
Reminder. The diagram below shows one supported stacking cable pattern. For additional supported
cabling patterns, refer to Chapter 6, “Managing OmniSwitch 6850E Series Stacks.”
Connecting the Switches in the Stack
To Next Page
Loading...
