Manual and Timed Crossfades
Crossfading between the scene set up on
the PRESETS and the stored scene is
achieved by moving the A MASTER and
B MASTER faders in tandem.
If the CROSSFADE control is set to
Manual, the crossfade time is determined
by the speed at which the A MASTER and
B MASTER faders are moved. The
operator has direct control over the speed
of the scene change.
If the CROSSFADE control is not set to
manual, the crossfade time will be the
time indicated on the CROSSFADE dial
(between 1 second and 5 minutes).
Flashing Channels in WIDE
1. Ensure that the FLASH FUNCTION is
active.
2. Press and hold an individual
CHANNEL FLASH button. The
buttons below the PRESET A faders
control channels 1 - 12 (1 - 24), those
below the PRESET B faders control
channels 13 - 24 (25 - 48). The
corresponding channel is then added
to the scene at the level set on the
GRAND MASTER.
3. Release the CHANNEL FLASH
button. The channel returns to its
previous level.
NOTES
Stored Scene
Any stored scene being output in PRESET
Mode will be removed from the outputs if the
desk is changed to PROGRAM or SUPER USER
Modes. If the desk is changed to RUN Mode
the stored scene remains on the outputs.
Page 16 Alcora 73-700-00 Issue 2
Preset Mode
To Next Page
Loading...