alcora Zero 88 - Run Mode; Introduction

Alcora 73-700-00 Issue 2 Page 27
Introduction
RUN Mode on the desk is used to replay
the previously recorded memories.
The programmed memories are stored in
a stack and can be replayed one at a time
in ascending numerical order. This allows
the complete show to be replayed in order
simply by pressing the GO NEXT button.
The MEMORY + and MEMORY - buttons
can also be used to select a particular
memory, which can then be output by
pressing the GO NEXT button.
The DISPLAY shows the next memory to
be output. The crossfade time, sequence
speed and attack can be adjusted using
the various front panel controls.
The output levels of a memory are
determined by the programmed levels in
the memory, the MEMORY MASTER and
the GRAND MASTER.
Individual desk channels can be mixed in
with the current memory outputs using the
PRESET faders. The channel are mixed
on a HTP basis.
The desk outputs 512 channels of DMX
all the time.