Alcora 73-700-00 Issue 2 Page 25
Program Mode
Using the Copy and Paste Buttons
The COPY and PASTE buttons are used
to copy memory data from one location to
another. The contents of a scene memory
or sequence step can be copied, and then
pasted into a different scene memory or
sequence step. The same memory data
may be copied into several destinations.
Copying a Scene Memory
1. Use the MEMORY + and MEMORY -
buttons to select a programmed
scene memory.
2. Press the COPY button. The contents
of the scene memory will be stored
internally. The light in the PASTE
button will be illuminated.
Copying a Sequence Step
1. Use the MEMORY + and MEMORY -
buttons to select a programmed
sequence memory.
2. Press the STEP + or STEP - button.
The DISPLAY will change from
displaying the memory number to
displaying the step number (1), and
the STEP light will be illuminated.
3. Use the STEP + and STEP - buttons
to select the step to be copied.
4. Press the COPY button. The contents
of the sequence step will be stored
internally. The light in the PASTE
button will be illuminated.
Pasting into a Scene Memory
1. Copy the required memory data (from
a scene memory or sequence step)
as described above. Ensure that the
light in the PASTE button is on.
2. Use the MEMORY + and MEMORY -
buttons to select a scene memory.
3. Press the PASTE button. The
memory data copied will be pasted
into the scene memory.
Pasting into a Sequence Step
1. Copy the required memory data (from
a scene memory or sequence step)
as described above. Ensure that the
light in the PASTE button is on.
2. Use the MEMORY + and MEMORY -
buttons to select a sequence
memory.
3. Press the STEP + or STEP - button.
The DISPLAY will change from
displaying the memory number to
displaying the step number (1), and
the STEP light will be illuminated.
4. Use the STEP + and STEP - buttons
to select the step into which the data
is to be pasted.
5. Press the PASTE button. The
memory data copied will be pasted
into the sequence step.
To Next Page
Loading...