Outputting a Sequence Memory
1. Use the MEMORY + and MEMORY -
buttons to select a sequence memory
to be output. The memory type is
indicated by the lights above the
MEMORY TYPE button.
2. Press the GO NEXT button to initiate
a crossfade to the selected memory.
The transition between the current
memory and the selected memory
depends on the position of the
CROSSFADE control.
3. When the sequence memory is being
output, the rate of advance (speed),
transition between steps and direction
can be adjusted using various front
panel controls as described below.
Moving between Sequence Steps
Manual Stepping
1. Ensure that the SPEED control is set
to Manual and the SOUND function is
not active.
2. Press the STEP + button to move to
the next step.
3. Press the STEP - button to return to
the previous step.
Automatic Stepping
1. Ensure that the SPEED control is not
set to Manual and the SOUND
function is not active.
2. Use the SPEED control to adjust the
rate at which the sequence is
advanced (the sequence speed).
Using Sound Input
A sequence can be advanced in time with
the bass beat of a music source, or the
basic speed of the sequence can be set
and the bass beat from the music source
used to increment extra steps.
1. Connect a suitable music source to
the audio input on the desk.
2. Ensure that the SOUND function is
active.
3. To use only the sound to trigger the
sequence, set the SPEED control to
Manual.
4. To use a combination of sound and
automatic, set the basic speed with
the SPEED control.
NOTES
Step Buttons
The STEP + and STEP - buttons are active at all
times while a sequence is running. They can
be used to advance or reverse the sequence
by one step. If either of these buttons are held
down for more than two seconds, the
sequence will advance for as long as the
button is held down.
Sound Input
If an external sound source attached to the
desk is used to advance a sequence, the
SOUND function must be activated using the
SOUND button.
Removing Sound Input
If the external sound source is removed, the
sequence will advance at the rate set on the
SPEED control. If the SPEED control is set to
Manual, the sequence will stop.
Page 32 Alcora 73-700-00 Issue 2
Run Mode
To Next Page
Loading...