Alcora 73-700-00 Issue 2 Page 33
Run Mode
Snap or Crossfade Between Steps
To snap from one sequence step to the
next set the CROSSFADE Control to
manual.
To crossfade from one step to the next
move the CROSSFADE control to any
timed setting.
If stepping is manual (via the STEP + and
STEP - buttons) the crossfade time is set
on the CROSSFADE control.
If stepping is automatic or sound
controlled, the sequence crossfades at a
rate set by the SPEED control.
Controlling Sequence Direction
The direction of a sequence is controlled
by the DIRECTION button. Press the
DIRECTION button to select the direction
required - Forwards (>), Backwards (<) or
Auto-Reverse (< >).
Previewing a Memory
An indication of the contents of the next
memory (as indicated by the DISPLAY)
can be obtained by previewing the
memory.
1. Press the PREVIEW/EDIT button.
The light in the button comes on.
2. The light in each of the CHANNEL
FLASH buttons will illuminate if the
corresponding channel in the memory
or sequence step is above 5%. If the
memory being previewed is a
sequence, the CHANNEL FLASH
buttons will indicate the contents of
each step in turn. The speed and
direction of the sequence will be
determined by the current settings of
the front panel controls (see section
on Outputting a Sequence Memory).
3. Press the PREVIEW/EDIT button.
The light in the button, and any lights
illuminated in the CHANNEL FLASH
buttons will go out.
To Next Page
Loading...