alcora Zero 88 - Editing a Sequence Steps Channels; Deleting a Sequence Memory; Converting Memory Types

Sequence Memories
Programming a New Sequence
1. Set up the desk for programming as
described on previous page.
2. Use the MEMORY + or MEMORY -
buttons to select an unprogrammed
memory.
3. Press and hold the MEMORY TYPE
button for 1 second to change the
memory type to Sequence.
The DISPLAY will show the first step
number with a decimal point to
indicate it is not programmed. The
STEP light will be illuminated.
4. Use the PRESET A and PRESET B
faders to set the required output
levels for the step. The output will
appear live.
5. Press the PROGRAM button. The
output levels are stored in the current
step of the sequence. The DISPLAY
automatically increments to the next
unprogrammed step number.
6. Use the PRESET A and PRESET B
faders to set the required output
levels for the next step. The output
will appear live.
7. Press the PROGRAM button to save
the current output levels into the step.
The DISPLAY automatically
increments and shows the next
unprogrammed step number.
8. Repeat steps 6 and 7until all steps in
the sequence have been
programmed.
Inserting a Step
1. Use the MEMORY + or MEMORY -
buttons to select the required
sequence memory.
2. Press the STEP + or STEP - button.
The DISPLAY will change from
displaying the memory number to
displaying the step number (1), and
the STEP light will be illuminated.
3. Use the STEP+ or STEP - buttons to
select a step. The new step will be
inserted after the selected step.
(eg, to insert a step between steps 4
and 5, select step 4).
4. Press the ADD STEP button. The
DISPLAY shows the inserted step
number with a decimal point
indicating that it is unprogrammed.
5. Use the PRESET A and PRESET B
faders to set the required output
levels for the new step. The output
will appear live.
6. Press the PROGRAM button to save
the output levels into the new step.
The decimal point disappears from
the DISPLAY.
Page 22 Alcora 73-700-00 Issue 2
Program Mode