Entering Run Mode
1. If the desk is in PRESET Mode or
SUPER USER Mode, press and hold
the MODE button for 1 second. The
desk will change to PROGRAM
Mode. When the desk is in
PROGRAM Mode press the MODE
button to enter RUN Mode.
2. Ensure that blackout is not active (the
light in the BLACKOUT button is off).
3. Select WIDE, if required.
4. Set all the PRESET faders and the
A MASTER and B MASTER to zero.
5. Set the MEMORY MASTER and
GRAND MASTER to full.
6. Set the CROSSFADE control to the
desired value.
Selecting the Next Memory
The DISPLAY indicates the next memory
to be output. The red NEXT light is
illuminated. The red lights above the
MEMORY TYPE button indicate the type
of the next memory. The MEMORY + and
MEMORY - buttons are used to select the
next memory to be output.
Pressing the MEMORY + button will take
you to the next programmed memory.
When the last programmed memory is
reached, pressing the MEMORY + button
will take you to the first programmed
memory.
Pressing the MEMORY - button will take
you to the previous programmed memory.
When the first programmed memory is
reached, pressing the MEMORY - button
will take you to memory zero (see notes).
The DISPLAY shows “0”. Pressing the
MEMORY - button again will take you to
the last programmed memory.
Pressing the MEMORY + and MEMORY -
buttons together will take you to memory
zero.
To Determine the Current Memory
Use the MEMORY + or MEMORY -
buttons to cycle through the programmed
memories.
When the memory number shown in the
DISPLAY is the same as the current
memory, the red CURR light next to the
DISPLAY is illuminated.
Page 30 Alcora 73-700-00 Issue 2
Run Mode
To Next Page
Loading...