alcora Zero 88 - Setting Recovery Mode; Clearing All Data (Clear All); Saving Memory Data to Module; Loading Memory Data from Module

Alcora 73-700-00 Issue 2 Page 35
Introduction
In SUPER USER Mode the presets and
memory functions are disabled. The user
has the options of setting recovery to on
or off, clearing all the programmed
memories and resetting the DMX patch,
patching the desk channels to the DMX
and saving or loading memory data.
WARNING
Only a Zero 88 memory module should
be connected to the 9 pin D type
connector on the rear panel of the desk.
It is advisable to switch the desk off
before connecting or disconnecting the
memory module.
Entering Super User Mode
To enter Super User Mode press and hold
down the STEP + and STEP - buttons
together, and then press and hold the
MODE button for 1 second.
The SUPERUSER light above the MODE
button comes on. The DISPLAY shows
the software version (eg A3.0).
Exiting Super User Mode
To exit SUPER USER mode press and
hold the MODE button for 1 second. The
desk will return to PROGRAM mode.