27
(3.3.1) Changing Kit Pieces for a Trigger Slot
To change a Kit Piece within a Trigger Slot, use one of these three options:
Via Main Encoder
While in Kit Edit mode, select the Trigger Slot you would like to change
by either tapping on the Kit display or by using the Hit Select feature.
Turn the Main Encoder to navigate the list of Kit Pieces. Once the new
Kit Piece is selected, push the Main Encoder to load the Kit Piece.
Via +/- Buttons
Press the +/- buttons to immediately load the next/previous Kit Piece
in the list.
Via “Tap to Load”
Select the Trigger Slot via the Kit display
graphic or use the Hit Select feature.
Browse the list of Kit Pieces by swiping
through the list. To highlight an item in
the list, simply tap it.
To load the Kit Piece, tap the check
mark.
Note: When a Kit Piece is highlighted in the search results window, you can tap from
left to right on the highlighted Kit Piece to hear the different velocity/dynamics of the
Kit Piece. This is good if you want to hear how a Kit Piece will play at different
dynamics. You can also tap on the drum kit graphic to audition one velocity. This can
be toggled on or off in the Settings menu.
To Next Page
