48
(3.6.4.2) SD (Snare), T1-T4 (Toms), Aux
Parameter Description Value Range
Curve
This determines how a sound’s volume is affected by
how hard you strike it—that is, how responsive the
trigger’s dynamics are to changes in your playing.
Linear
Log 1
Log 2
Log 3
Log 4
Exp 1
Exp 2
Exp 3
Exp 4
Spline 1
Spline 2
Spline 3
Spline 4
Offset
Constant
Head Sensitivity Controls how responsive the pad’s head is when hit.
The higher the value, the less forcefully you need to
play to generate a loud hit.
1.0 – 32.0
Rim Sensitivity This adjusts the sensitivity of a dual zone drum pad’s
rim when triggered.
1.0 – 32.0
Head Threshold This sets at what point a trigger signal is received
when a pad is struck above the set velocity. This sets
at what point a trigger signal is received when a pad
is struck above the set velocity. This parameter is
useful if you have a nearby speaker or other loud
interference which is causing your drum/cymbal to
falsely trigger. In the Trigger Edit mode, you can use
the signal meters to identify which triggers are
receiving the interference, then turn up the Threshold
for that Trigger Input until it is removed. Careful! If
you turn up the Threshold too high, you will lose the
ability to play softer dynamic levels.
1 – 127
Rim Threshold This adjusts how hard you have to hit the dual zone
pad to generate a sound from the rim. The higher the
value, the harder you have to hit it.
1 – 127
To Next Page
