Page Tone
Select a pre-announce tone for paging. This tone will play to announce a Page is starting. Use only the Default or
custom uploaded files. Other pre-installed tone files contain silence at the end to generate ring "cadence" of 6
seconds. This silence will block the voice path for several seconds at the start of a page. The “Default” tone will play
the page-notif.wav file.
G.722 Support
G.722 enables wideband audio for optimum speech intelligibility. Enable or disable the G.722 codec.
Passcode Protected Page Extensions
When enabled, the caller must enter the passcode followed by the # sign before the page can be accepted. Setting a
passcode helps prevent unintentional pages. Passcodes can be up to 15 digits and must be numbers only.
Apply to All Page Extensions
Only visible when ‘Passcode Protected Page Extensions’ is set to ‘Enabled’. Choose to apply a passcode to all page
extensions.
Passcode
Only visible when ‘Passcode Protected Page Extensions’ is set to ‘Enabled’. Enter the desired numerical passcode
(maximum length of 15 digits).
Passcode Prompt Tone
Only visible when ‘Passcode Protected Page Extensions’ is set to ‘Enabled’. Select the tone to be played to notify the
user to enter the passcode before paging.
DTMF Detection Type
Select the preferred dual-tone multi-frequency (DTMF) detection method. DTMF is a technology used with touch tone
phones, best known to users as the sound made when pressing a number key. In the 8301, this is used for multi-zone
selection, passcode, etc.
Audio Processing
Ambient Noise Compensation
Ambient Noise compensation will allow the speaker level to adjust automatically in response to ambient noise levels
detected at the device prior to the start of each call. The 8301 requires an external microphone wired in.
To Next Page
Loading...
