Alinco DR-435 - Specifications; General Specifications; Transmitter Specifications; Receiver Specifications

2
SPECIFICATIONS
General
Frequency coverage DR-135 DR-235 DR-435
118.000 ~ 135.995MHz (AM RX) 216.000 ~ 279.995MHz (RX) 350.000 ~ 511.995MHz (RX)
136.000 ~ 173.995MHz (RX) 222.000 ~ 224.995MHz (TX) 430.000 ~ 449.995MHz (TX)
144.000 ~ 147.995MHz (TX)
144.000 ~ 145.995MHz (RX.TX) 430.000 ~ 439.995MHz (RX.TX)
TA,TAG 118.000 ~ 135.995MHz (AM RX)
(Commercial) 136.000 ~ 173.995MHz (RX.TX)
Operating mode
Frequency resolution
Number of memory
channels
Antenna impedance
Power requirement
Ground method
Current drain Receive 0.6A(Max.) 0.4A(Squelched)
Transmit 11.0A max. 8.0A max. 10.0A max.
Operating temperature
Frequency stability
Dimensions
Weight
Transmitter
Output power High:50W (144-148MHz) High:25W High:35W
More than 33W (136-174MHz)
Mid:10W Mid:10W Mid:10W
Low:Approx.5W Low:Approx.5W Low:Approx.5W
Modulation system
Maximum frequency
deviation
Spurious emission
Adjacent
channel power
Noise and hum ratio
Receiver
Sensitivity
Receiver circuitry
Intermediate
frequency
Squelch sensitivity
Adjacent channel
selectivity
Intermoduration
rejection ratio
Spurious and
image rejection ratio
Audio output power
! Note: All specifications are subject to change without notice or obligation.
2.0W (8 ,10%THD)
70dB
60dB
-65dB(Wide mode) -55dB(Narrow mode)
-18dBu
Double conversion superheterodyne
-16dBu for 12dB SINAD
2k
-40dB (Wide mode) -34dB (Narrow mode)
-60dB
-60dB
±5kHz (Wide mode) ±2.5kHz (Narrow mode)
Variable reactance frequency modulation
142(w)×40(h)×174(d) mm
( 142×40×188mm for projection included)
Approx. 1.0kg
E,EG
(European amateur)
T,TG
(U.S amateur)
- 10 to 60
±5ppm
FM 16K0F3E (Wide mode) 8K50F3E (Narrow mode)
5,8.33,10,12.5,15,20,25,30,50 KHz
100
50 unbalanced
13.8V DC ±15% (11.7 to 15.8V)
Negative ground
˚C ˚C
Microphone impedance
1st 21.7MHz 2nd 450kHz 1st 30.85MHz 2nd 455kHz 1st 30.85MHz 2nd 455kHz
Downloaded by
RadioAmateur.EU