44 Rockwell Automation Publication 1734-UM018D-EN-E - September 2017
Chapter 4 Configure the Adapter for Direct Connection in RSLogix 5000 or Logix Designer Software
Add the Digital Output Module
1. Highlight the 1734-AENT/B adapter under the I/O Configuration
folder, right-click and select New Module.
The Select Module Type dialog opens.
2. Select the appropriate Module Type Category Filter (for the example we
selected Digital) and Module Type Vendor (for the example, we selected
Allen-Bradley).
Note: to select only one category you will need to unselect those already
selected.
3. From the modules listed select the 1734-OV4E sink output module and
click Create.
To Next Page
Loading...
