Rockwell Automation Publication 1734-UM018D-EN-E - September 2017 45
Configure the Adapter for Direct Connection in RSLogix 5000 or Logix Designer Software Chapter 4
The New Module dialog opens.
4. Enter values for Name and Slot, noting that we used the following values.
5. Choose the Connection tab to set the RPI value.
The RPI is selectable since it is a direct connection.
Note that the RPI is selectable and has a default value. Because we are
making a direct connection to each I/O module, we must specify an RPI to
determine how often the data is exchanged with the adapter for each
module.
Name POINT_Digital_Output
Slot 2
To Next Page
Loading...
