90 Rockwell Automation Publication 5000-UM005B-EN-P - November 2015
Chapter 6 Configure the Module
Connection Category
The Connection tab lets you complete the following tasks:
• Set the RPI rate. For more information about the RPI, see
Requested
Packet Interval on page 15.
• Set the connection type to use on the EtherNet/IP network.
For more information on Unicast and Multicast connections, see the
EtherNet/IP Communication Modules in 5000 Series Systems User
Manual, publication
ENET-UM004.
• Inhibit the module. For more information on how to inhibit the module,
see
page 29.
• Configure whether a connection failure while the controller is in Run
module causes a major or minor fault.
TIP
The Module Fault area of the Connection category is useful during module
troubleshooting. For more information on the Module Fault area, see
page 131
To Next Page
Loading...
