Operating Instructions
Part No. 70458301ENR7
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT 111
Figure 35
NOTE: Do not press directly on lights or the center
of pad. For proper selection, press on pad slightly
to the right of center. Refer to Figure 36 .
Figure 36
2. Select REVERSING or NONREVERSING cylinder
rotation setting.
Figure 37
3. Press START pad to start tumble dryer.
Figure 38
NOTE: All pads can be pressed in any sequence
without damaging control or tumble dryer. To stop
the tumble dryer at any time, open the door or
press STOP/RESET.
Figure 39
NOTE: The window display will flash. Press STOP/
RESET twice (within three seconds) to end the
cycle and reset the control to idle status. To restart
the tumble dryer, CLOSE door and press START
pad.
IMPORTANT: If the loading door or lint panel door
is opened during the cycle, the heating system
will shut off and the motor will stop. To restart the
cycle, both doors must be closed and START pad
must be pressed.
4. When the cycle is complete, open door and remove the
laundry.
WARNING
To prevent the risk of fire, remove laundry
immediately in case of power failure.
W779
NOTE: This machine includes an anti-wrinkle/
extended tumble feature. After the drying cycle
is complete, the cylinder will tumble without heat
every few minutes. The intermittent tumbling will
continue for one hour or until the door is opened.
Single Drop Control
SD and SX Control Suffixes
1. Select HIGH, MED, LOW or NO HEAT by turning the
temperature knob.
HIGH Temperature 190°F
(88°C)
MED Temperature 160°F
(71°C)
LOW Temperature 130°F
(54°C)
Figure 40
2. Insert the coin(s) in the coin slot.
To Next Page
Loading...
