Operating Instructions
114
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT Part No. 70458301ENR7
IMPORTANT: To stop the tumble dryer at any time
during a cycle, OPEN DOOR. To restart the tumble
dryer, CLOSE door and press START pad.
4. When the cycle is complete, open door and remove the
laundry.
WARNING
To prevent the risk of fire, remove laundry
immediately in case of power failure.
W779
NOTE: This machine includes an extended tumble
feature. Starting 20 minutes after a cycle ends,
the cylinder will tumble for two minutes every
hour without heat, up to 18 hours or until door is
opened.
Figure 47
LED OPL Control
EO and RE Control Suffixes
1. Press the Up or Down keypad to change cycles.
To customize a cycle, refer to the Programming Manual.
2.
Press START ( ) to start selected cycle.
IMPORTANT: If the loading door or lint panel door
is opened during the cycle, the heating system
will shut off and the motor will stop. To restart the
cycle, both doors must be closed and the START (
) pad must be pressed.
3. When the cycle is complete, open door and remove laundry.
WARNING
To prevent the risk of fire, remove laundry
immediately in case of power failure.
W779
To Next Page
Loading...
