Operating Instructions
116
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT Part No. 70458301ENR7
C, D, and I Models
Figure 50
UniLinc Control
UO and RU Control Suffixes
1.
Press the or keypad to change cycles. The center
highlighted position is the selected cycle.
To customize a cycle, refer to the Programming Manual.
2.
Press START to start selected cycle.
IMPORTANT: If the loading door or lint panel door
is opened during the cycle, the heating system
will shut off and the motor will stop. To restart the
cycle, both doors must be closed and the START
pad must be pressed.
3. When the cycle is complete, open door and remove laundry.
WARNING
To prevent the risk of fire, remove laundry
immediately in case of power failure.
W779
NOTE: This machine includes an anti-wrinkle/
extended tumble feature. After the drying cycle
is complete, the cylinder will tumble without heat
every few minutes. The intermittent tumbling will
continue for one hour or until the door is opened.
After an hour the machine enters delayed tumble
and will tumble for two minutes every hour for up
to 18 hours or until the door is opened.
To Next Page
Loading...
