Operating Instructions
120
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT Part No. 70458301ENR7
Safety Tumble/Anti-Wrinkle
At the end of the cool down cycle, the tumble dryer will stop and
display “END.” The DMP control will automatically rotate the
basket for 5 seconds every 2 minutes for a total of 20 minutes,
until some function of the tumble dryer is activated/deactivated
by the user.
Operational Check for the Board Diagnostics
1. “dor” indicates that the loading or lint door is open.
2. Cycle the tumble dryer to check if the buzzer activates.
3. “P-F” indicates that the thermistor is short circuited or open
circuited.
4. “bbt” indicates a broken belt condition or a faulty rotation
sensor. (Only available on tumble dryers with the rotation
sensor.)
5. Hold the START button to display the drum RPM’s; the
display will read “r##” where ## are the RPM’s. (Only
available on tumble dryers with the rotation sensor.)
DMP OPL Models
DO Control Suffix
1
START. Starts or resumes the current program or cycle.
2
STOP. Temporarily halts the current cycle or cancels the current program.
3
Reversing/Nonreversing (REV). Changes the selection between reversing and nonreversing cylinder action.
4
Reversing LED. Illuminated when set for reversing.
5
Up/Down Arrows. Increases or decreases the value in the display. In conjunction with the DISPLAY button, these buttons are
used to adjust the drying time, cooling time, temperature, clockwise time, dwell time, counter-clockwise time, and minutes per
coin (Coin only).
6
Display. Displays the drying time, cooling time, drying temperature and diagnostic codes.
7
Program Select. This button toggles through the five user programmable programs. Holding this button will save a program, as
indicated in Programming.
8
User Program LEDs. Illumination shows which user program is currently being displayed.
9
Display Select. Toggles the display between the drying time, cooling time, and temperature settings. Pressing the Display
button for 3 seconds allows the user to display the drying cycle temperature.
10
DRYING LED. Illuminated when in the drying cycle.
11
COOLING LED. Illuminated when in the cooling cycle, or when the display is currently showing the time for the cooling
cycle.
12
TEMPERATURE LED. Illuminated when the display is showing the temperature setting.
Figure 54 Description of the OPL Control Panel
To Next Page
Loading...
