Operating Instructions
122
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT Part No. 70458301ENR7
position enables the display of “PAy”, to indicate that coins
are needed to run the tumble dryer.
8. Programming: This switch enables or disables the
programming feature and should normally be in the OFF
position.
DMP Coin
DV and DX Control Suffixes
Description of The Coin Control Panel
1
Clock Symbol. This symbol of a clock indicates that the
time in the display is counting down to zero.
2
Display. Displays the drying time, cooling time, drying
temperature, and diagnostics.
3
Hidden Keys. Used for programming in the coin mode
– increases or decreases the value in the display. In
conjunction with the START button, these buttons are
used to adjust the drying time, cooling time, temperature,
clockwise time, dwell time, counterclockwise time, and
minutes per coin.
4
Temperature LEDs. Indicate temperature setting.
5
DRYING LED. Illuminated when in the drying cycle.
6
Instructions. Instructions to start a drying cycle.
7
COOLING LED. Illuminated when in the cooling cycle
or when the display is currently showing the time for the
cooling cycle.
8
START. Starts or resumes the current program or cycle.
9
Temperature Select. This button toggles through the
three temperature selections.
Figure 55
Coin Keypad Interface
- START button to start or resume a cycle.
- TEMP button to select HIGH, MEDIUM, or LOW
temperature.
- Two hidden buttons to increment or decrement the
programmable time and temperature options.
Power-Up
Upon applying power to the tumble dryer, the display will show
“PAy” and the DRYING and COOLING LEDs will be off until
coins are deposited to increase the tumble dryer run time. When
time is displayed, the default (LOW) temperature setting LED
will be on until a different temperature setting is selected.
Power Failure
If a power loss occurs during operation, a cycle will not resume
until the START button is pressed. To cancel the remaining
cycle, press the internal CLEAR button.
Coin Operation
The tumble dryer run time is determined by the pre-programmed
run time per coin and the number of coins deposited into the
tumble dryer. The maximum time that can be accumulated
and displayed is 99 minutes. The drying time is the difference
between the run time and the cooling time. The cooling time is
pre-programmed to be 2 to 5 minutes. The drying temperature
can be selected from LOW, MEDIUM, or HIGH temperature
settings by pressing the TEMP button.
Coin Programming
The Coin board programming mode can only be entered when
“PAy” is displayed. DIP switch #7 must be in the off position.
Programming is enabled by setting DIP switch #8 to the ON
position.
The programming mode is entered by pressing and holding the
CLEAR button for three seconds.
The programming follows the following parameter order:
1. Tumble dryer run time per coin (DRYING), COOLING
time, HIGH temperature setpoint, MEDIUM temperature
setpoint, LOW temperature setpoint.
2. An LED will be on to indicate which parameter is flashing
on the display.
3. The hidden front panel increment and decrement keys are
used to change the value.
4. The CLEAR button is used to recall the default value.
5. The START button is used to step to the next parameter.
6. After the last parameter, “End” will be flashing.
To Next Page
Loading...
