Allied Telesis GS950 PS V2 Series - Features; Copper Ports; Power over Ethernet Plus; SFP Slots

GS950 PS V2 Series of Gigabit Ethernet PoE+ Switches Installation Guide
21
Features
Here are the hardware features of the switches.
Copper Ports Here are the basic features of the copper ports:
 10/100/1000Mbps
 10Base-T, 100Base-TX and 1000Base-T compliant
 IEEE 802.3u Auto-Negotiation compliant
 Auto-MDI/MDIX
 100 meters (328 feet) maximum operating distance
 IEEE 802.3x Flow Control in 10/100Mbps full-duplex mode
 IEEE 802.3x Back Pressure in 10/100Mbps half-duplex mode
 IEEE803.3z 1000Base-T Flow Control
 Support for Jumbo frames up to 10KB
 RJ-45 connectors
Power Over
Ethernet Plus
Here are the basic features of PoE+:
 Supported on all copper ports on the GS950/10PS V2,
GS950/18PS V2, and GS950/28PS V2 Switches
 Supported on copper ports 1 to 24 on the GS950/52PS V2 Switch
 Maximum power budgets:
— GS950/10PS V2: 75W
— GS950/18PS V2: 185W
— GS950/28PS V2: 185W
— GS950/52PS V2: 370W
 PoE (15.4W at port) and PoE+ (30W at port)
 Powered device classes 0 to 4
 Per port power control
 Port priority assignments to control power distribution
 Link Layer Discovery Protocol (LLDP) for Class 4 PoE+ devices
 Alternative A mode wiring (pins 1, 2, 3, and 6)
SFP Slots The SFP ports support the following types of transceivers:
 100Mbps SFP 100Base-FX fiber optic transceivers
 1000Mbps SFP 1000Base-SX/LX fiber optic transceivers