GS950 PS V2 Series of Gigabit Ethernet PoE+ Switches Installation Guide
31
POWER LED The GS950/10PS V2 Switch has a POWER LED on the left side of the
faceplate. Refer to Figure 9.
Figure 9. POWER LED
Table 5 defines the LED states.
PoE MAX LED The switches have a PoE MAX LED on the left side of the faceplate. Refer
to Figure 8 on page 30. Table 6 defines the states of the PoE MAX LED.
Link/Activity and
PoE LEDs
The copper ports have link/activity and PoE LEDs.The LEDs on the
GS950/10PS V2, GS950/28PS V2, and GS950/52PS V2 Switches are
located on the left side of the faceplate. The LEDs in the example in Figure
10 on page 32 are from the GS950/28PS V2 Switch.
Table 5. POWER LED
State Description
Off The switch is not receiving AC power or has experienced
a system failure.
Green The switch is operating normally.
Table 6. PoE MAX LED
State Description
Off The total power requirements of the powered devices
connected to the ports are below the switch’s maximum
power budget. The switch is providing power to all
powered devices on its ports.
Red The total power requirements of the powered devices
meet or exceed the switch’s maximum power budget.
The switch cannot support additional powered devices
and may be denying power to some ports.
To Next Page
Loading...
