49
Chapter 3
Installing the Switch on a Table or
Desktop
This chapter contains the instructions for installing the switch on a table or
desktop.
Switches should not be stacked on a table or desktop. They could
present a physical safety hazard if you need to move or replace
switches. E91
The device is heavy. Use both hands to lift it. You might injure
yourself or damage the device if you drop it. E94
Airflow in the switch is from left to right, when facing the front of the
device.
To install the chassis on a table, perform the following procedure:
1. Review “Reviewing Safety Precautions” on page 40 and “Choosing a
Site for the Switch” on page 46 to verify that the selected site is
suitable for the unit.
2. Verify that the table is strong enough to support the weight of the
switch.
3. Verify that the accessory kit came with all the appropriate items. Refer
to “Unpacking the Switch” on page 47.
4. Lift the chassis from the shipping box and place it upside down on a
table.
5. Affix the bumper feet to the four corners on the bottom panel of the
switch. Refer to Figure 20 on page 50.
To Next Page
Loading...
