Allied Telesis GS950 PS V2 Series - Figure 36: Marking the Screw Holes for the BRKT-J22 Brackets

Chapter 5: Installing the Switch on a Wall
72
Note
Wall anchors and screws are not provided with the brackets. The
diameter of the bracket screw holes is 4mm.
To install the GS950/52PS V2 Switch on a wall with the BRKT-J22
Brackets, perform the following procedure:
1. Have one person hold the switch on the wall at the desired location.
2. Have another person position the brackets and mark the eight screw
holes. Refer to Figure 36.
Figure 36. Marking the Screw Holes for the BRKT-J22 Brackets
3. Place the switch on a table.
4. Drill the screw holes.
5. Install wall anchors, if required.
6. Attach the bottom brackets to the wall with appropriate screws. Refer
to Figure 37 on page 73. Be sure that the bracket flanges are on the
outside.