Allied Telesis GS950 PS V2 Series - Figure 42: Positioning the SFP Handle in the Upright Position; Figure 43: Connecting a Fiber Optic Cable to an SFP Transceiver

Chapter 6: Cabling the Networking Ports
80
5. Verify the position of the handle on the SFP transceiver. If the
transceiver is in a top slot, the handle should be in the upright position,
as shown in Figure 42. If the transceiver is in a bottom slot, the handle
should be in the down position.
Figure 42. Positioning the SFP Handle in the Upright Position
6. Connect the fiber optic cable to the transceiver, as shown in Figure 43.
The connector on the cable should fit snugly into the port, and the tab
should lock the connector into place.
Figure 43. Connecting a Fiber Optic Cable to an SFP Transceiver
7. Repeat this procedure to install additional transceivers.
SFP Handle