16 Rapier Series Switch
C613-03020-00 REV K
• Check “Diagnostics Messages” to display additional diagnostic
messages in the AT-TFTP window when debugging file transfers.
• Choose whether AT-TFTP Server should respond to TFTP requests
received via IPv4 only, IPv6 only, or both IPv4 and IPv6.
• Click the OK button when you finish.
3. To download a file from AT-TFTP Server to your switch, at the switch’s
command line interface type the following command:
load method=tftp file=filename server=ipadd dest=flash
where filename is the name of the file to download and ipadd is the IP
address of the PC running AT-TFTP Server.
4. TFTP requests are logged to the AT-TFTP Server main window. To save a
TFTP Server log, select Save As from the File menu.
To Next Page
Loading...
