299400001-J1 Rev F
LED Indication
Each L-ADIO contains three LEDs for peripheral status indication.
LVD – Yellow = LVD Override Engaged
Power – Blue = Power present to device
Comms – Green = L-ADIO has been acquired by the controller
Front Panel Reset Button
A reset button is located on the front panel. It takes approximately 15 seconds before the unit is reacquired after
pressing the reset button.
During a reset condition, the L-ADIO will keep relays in their last known state to prevent false alarm notifications and
possible changing system LVD states.
CAUTION – Pressing the reset button will cause the L-ADIO to lose communication with the controller.
LVD Override
An LVD Override button is provided to keep any relays assigned to LVD function in a static state. The override func-
tion should be used whenever performing controller maintenance such as test relay functions, or when replacing a
controller.
To engage the LVD override function, press and hold the button for three seconds. A yellow indicator LED will signal
that the override is engaged. To restore back to normal LVD operation, press and hold the LVD button again for three
seconds.
4.6.2 6I-ADIO
The 6I-ADIO is an analog input peripheral providing six isolated shunt inputs. The 6I-ADIO communicates on CAN
bus to the controller and provides access to shunt inputs via the controller.
Six current input channels, I1 – I6, provide monitoring of current; e.g., discharge (load) and charge (battery). The con-
troller is capable of monitoring standard shunts of 25mV, 50mV and 100mV as well as application specifications of
up to 250mV. The shunt current rating can be configured via the controller and is set by default to 800A/25mV. The
input range for this signal is -250mV to +250mV.
Figure 25 — 6I-ADIO Peripheral
To Next Page
Loading...
