Altronic DE-2500 - Servicemeter Alerts and Messages; Servicemeter Alerts and Viewing Messages

-12-
9.5 Whenever a programmed servicemeter interval has expired, a * character will be displayed at
the end of the STATUS word on the top line of the HOME screen. If programmed to do so,
when using Terminal version 2.0 or above, Digital control output #7 will turn “ON” when any
service meter interval has expired. This output can be used to trigger a horn or light or to
initiate a service call. The servicemeter will show the hours remaining until a scheduled service
function is required. When a service function is overdue, the hours left will display 0. Press the
F1 key to display the servicemeter messages.
STATUS* RUNNING
SPEED 1000 RPM
SUCTION 102.3 PSIA
DISCHARGE 300 PSIG
F1
Press to
view
message
HOURMETER / SERVICE
MESSAGE NUMBER:00
TOTAL HOURS: 8971
OPERATING HOURS

UNITS
press to
change
number
HOURMETER / SERVICE
MESSAGE NUMBER: 01
HOURS LEFT: 100
OIL CHANGE REQUIRED

UNITS
press to
change
number
Proceed through the servicemeter messages to find the required service. The number of
hours left until the listed maintenance is due is displayed for each service message. When
the hours left reaches zero the * character is displayed on the home screen status line.
HOURMETER / SERVICE
MESSAGE NUMBER: 02
HOURS LEFT: 0
OIL CHANGE REQUIRED

UNITS
press to
change
number
F2
press to
reset
hours left