Altronic DE-2500 - Editing Time, Date, and Communications; Viewing and Editing Time and Date

-33-
14.10 (continued)
NEXT
press to
select
OUTPUT 1 2
DELAY TIME 6 SEC
N/O N/C IGN
ENTER
press to
accept
the value
change
Upon pressing the ENTER key, a diamond will replace the selection arrow. To view or edit
the next output number, press the NEXT or TENS or TENS keys until the arrow points
to the desired output number and repeat the process.
14.11 To view or edit the time and date, select “EDIT SAFETY SHUTDOWN” from the main menu.
Select “MORE MENUS” from the following menu. Finally, select “EDIT TIME AND DATE”
from the last menu.
OUTPUT CONFIG.
 EDIT TIME AND DATE
COMMUNICATIONS
TO PREVIOUS MENU
from
ENTER
press
The time and date will be displayed with the selection arrow pointing to the time. The hours,
and minutes can be edited separately, AM and PM follow the hours. With the selection arrow
pointing to the hours, use the UNITS or UNITS keys to increase or decrease the hours.
Press ENTER to save the new hour setting; the selection arrow will point to the minutes. Use
the same procedure to edit the minutes. Use the NEXT key to move through the time and
date screen without making a permanent change in memory.
TIME: 11:30 AM
DATE: 09-03-2000