Altronic DE-2500 - Viewing Channel Status Screens; Viewing Channel Status and Navigation

-21-
NOTE: Screens three and four display in digital and bargraph from the second group of four
selected analog inputs.
TEMP 1 180 °F
TEMP 2 250 °F
TEMP 3 300 °F
TEMP 4 320 °F
then at
VIEW
press to
view
bargraph
screen
TEMP 1 L H
TEMP 2 L H
TEMP 3 L H
TEMP 4 L H
then at
VIEW
press to
view next
process
screen
ESC
press
to
escape
Note: On DE-2500 units programmed using Terminal Program 2.0 or above two additional
process screens are available, to allow the display of up to 12 process channels.
11.0 VIEW CHANNEL STATUS SCREENS
11.1 Use the VIEW CHAN key to enter the view channels screens. Once in the VIEW CHAN
mode, the user can view any channel’s details.
- The first line will be the controller system status; “TIMERS ACTIVE”, “RUNNING”,
“FAULT AL12', or “MANUAL STOP”.
- The second line shows whether the input point is “ARMED” or “NOT ARMED”. Class
A points will always be armed; class B points become armed only after their timers have
timed out. Class C points arm when cleared or when the timer times out.
- The third line shows the channel number and an analog value of that input; if configured
for that channel.
- The fourth line shows the user entered 20 character channel description.
Upon pressing the view channel key, channel 10 will be shown. The UNITS and TENS keys
allow the user to quickly navigate through the controller channels. Use the  UNITS or 
UNITS keys to increase or decrease the viewed channel by one. Use the  TENS or 
TENS keys to increase or decrease the viewed channel by ten. To exit the VIEW CHAN
mode, press the ESC key. After five minutes with no keypad activity, the display will revert
back to the current home screen.