组装说明 ASSEMBLY SECTION
131T 斜主齿轮
131T Slant Thread Main Drive Gear
Chapter 17
13
131T 斜主齿轮
131T Slant Thread
Main Drive Gear
主齿中心座
Main Gear Case
半圆头内六角螺丝
Socket Button Head Collar Screw
M2x4mm
出厂零件包装如果是已组装品，请务必确认各部件是否
锁紧上胶。
For original manufactory package, If the product is
already assembled by factory, please check again if
parts are firmly secured and applied with some glue.
单向轴承
One-Way Bearing
Φ10xΦ14x12mm
6
48
已经完成组装
AIready Assembled
主齿中心座
Main Gear Case
字面向上
Literally Facing Up
DX360-F
DX360-F
上齿盘固定座
Front Tail Pulley Hub
Chapter 18
单向轴承套
One-way Bearing Sleeve
上齿盘固定座
Front Tail Pulley Hub
前尾驱动皮带轮
Front Tail Pulley
Chapter 19
DX360-F
逆牙方向锁入
Tighten it with invers thread
direction
使用高强度缺氧胶，并确保锁入最底，
建议静摆24小时后再进行组装飞行。
Use high strength hypoxic glue, and
make sure it was locked to the end of
thread. It is recommended to leave
for 24 hours before assembling on
the fuselage.
装配时请特别注意，要确保两个零件水平后锁入，避免伤及零件
螺纹。
Attention: to avoid damage the thread , please ensure that
both parts are locked horizontally when assembling it.
前尾驱动皮带轮
Front Tail Pulley
平头内六角螺丝
Socket Flat Head Screw
M2x4mm
前尾驱动皮带轮零件
Front Tail Pulley Parts
螺丝锁入塑胶零件请勿过度拧紧。
Do not over-tighten the screws
into the plastic parts.
螺丝锁入塑胶零件请勿过度拧紧。
Do not over-tighten the screws
into the plastic parts.
To Next Page
Loading...
