4
自备设备 EQUIPMENT REQUIRED FOR ASSEMBLY
自备遥控及电子设备 RADIO TRANSMITTER AND ELECTRONIC EQUIPMENT REQUIRED FOR ASSEMBLY
● 遥控器 (六通道及以上直升机模式遥控器)
● 接收器 (六通道及以上)
● 数字螺距规
● 锂电池 (1400~1600mAh 22.2V 6S Li-Po) 宽高尺寸限制在 34x34mm 以内。
● 无刷马达 (1800KV 3.5mm 6S) /标准版配备 高级套装版配备
● 无刷电调 (40~60A) /标准版配备 高级套装版配备
● 倾斜盘舵机 x 3 (建议使用扭力 3KG*cm 以上舵机) 高级套装版配备
● 锁尾舵机 ( ) 建议使用扭力 4Kg*cm 以上、速度 0.06~0.04秒舵机 高级套装版配备
● 无副翼陀螺系统 高级套装版配备
● Transmitter (6-channel or more, helicopter system)
● Receiver (6-channel or more)
● Digital Pitch Gauge
● Li-Po Battery (1400~1600mAh 22.2V 6S ) With the size within 50x53mm.
● Brushless Motor (1800kv 6S 3.5mm spindle) Combo/Super Combo
● Brushless ESC (40~60A) Combo/Super Combo
● Swashplate Servos x 3 (Recommend to use 3KG*cm or higher torque servo) Super Combo
● Locked Rudder Servo ( ) Recommend to use above 4kg*cm torsion and with speed of 0.06~0.04s servo Super Combo
● 3-Axis Gyro System Super Combo
自备工具 ADDITIONAL TOOLS REQUIRED FOR ASSEMBLY
● 内六角螺丝刀 (0.9mm/1.5mm/2.0mm/2.5mm)
● 内六角套筒 (5.5mm)
● 243 螺丝胶
● 648 轴承胶
● Grease 润滑油
● CA 瞬间胶
● Hexagon Screw Driver (0.9mm/1.5mm/2.0mm/2.5mm/3.0mm/4.0mm)
● Hex Fork Wrench (5.5mm/7.0mm)
● 243 Thread Lock
● 648 Anaerobics Retain
● Grease
● CA Glue
● 剪刀
● 刀子
● 斜口钳
● 尖嘴钳
●卡簧钳
● 砂纸
● 焊接工具
● Scissors
● Cutter Knife
● Diagonal Cutting Pliers
● Needle Nose Pliers
● Circlip Pliers
● Sand Paper
● Soldering Equipment
To Next Page
