尾旋翼组
Tail Rotor Assembly
Chapter 38
组装说明 ASSEMBLY SECTION
23
尾旋翼夹座组
Tail Rotor Holder Assembly
Chapter 37
尾旋翼夹座
Tail Rotor Holder
尾旋翼T型座
Tail Rotor Hub
定期检查更换。
Periodic inspection
and replacement.
轴承
Bearing
Φ3xΦ6x2.5mm
尾旋翼夹座
Tail Rotor Holder
推力轴承
Thrust Bearing
Φ3xΦ6x2.8mm
垫片
Washer
Φ3xΦ4.6x0.6mm
轴承
Bearing
Φ3xΦ6x2.5mm
圆头内六角螺丝
Socket Head Screw
M2x6mm
2
4
3
组装时，确保尾夹座顺滑，些微干涉将可能导致飞行时
尾动作不顺畅。
Care must be taken during assembly to ensure tail
grips operate smoothly without binding. Any slight
binding may affect tail action during flight.
出厂零件包装如果是已组装品，请务必确认各部件是否
锁紧上胶。
For original manufactory package, If the product is
already assembled by factory, please check again if
parts are firmly secured and applied with some glue.
内孔较大在里面
Larger ID Inside
凹槽面朝内
The Groove Faces Inward.
已经完成组装
AIready Assembled
第35步组装完成
Assembled in Chapter 35
第36步组装完成
Assembled in Chapter 36
第37步组装完成
Assembled in Chapter 37
止泄螺丝
Set Screw
M3x3mm
243
圆头内六角轴套螺丝
Socket Collar Screw
M2x8mm
圆头内六角轴套螺丝
Socket Collar Screw
M2x8mm
铜套
Collar
Φ2xΦ3x3.1mm
铜套
Collar
Φ2xΦ3x3.1mm
止泄螺丝 M3x3mm 固定点。
Set screw M3x3mm anchor point.
用手推动数次，确保滑块组推动顺畅及尾旋翼夹
座摇摆顺畅。如果感觉些微干涉，请调整拉杆螺
丝松紧，直到顺畅为止。
Push several times with hand to ensure tail
pitch slider and tail rotor set swing smoothly,
if it feels slightly interference, please adjust the
tightness of screw rod, until smooth.
适当拧紧螺丝，不可硬拧以避免螺丝受损，影响飞行安
全性。
Tighten the screws properly. Do not over-tighten and
damage the screws or it will affect flight safety.
DX360-K
DX360-K
To Next Page
Loading...
